9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951

9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951
9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951
9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951
9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951
9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951
9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951
9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951

9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951

1200x825, 9.7inch E-Ink display HAT for Raspberry Pi, IT8951 controller, USB/SPI/I80/I2C interface. This is an E-Ink display HAT for Raspberry Pi, 9.7inch, 1200x825 resolution, with embedded controller IT8951, communicating via USB/SPI/I80/I2C interface.

Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on. No backlight, keeps displaying last content for a long time even when power down. Low power consumption, basically power is only required for refreshing. Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+.

USB/SPI/I80/I2C interface, for connecting with host boards like Raspberry Pi/Nucleo, etc. Comes with development resources and manual (examples for Raspberry Pi/STM32). Outline dimension: 218.8mm × 156.425mm × 1.15mm. Display size: 202.8mm × 139.425mm.

Dot pitch: 0.169 × 0.169. Gray scale: 2-16 (1-4 bit). Total refresh power: 0.6Wtyp. Total standby power: 0.3Wtyp. SPI chip selection, low active.

Busy status output, low active. E-Paper IT8951 Driver HAT Dimensions. E-Paper IT8951 Driver HAT x1. 9.7inch e-Paper Adapter x1. 33PIN FFC (same side contact) x1.

RPi screws pack (2pcs) x1. PH2.0 20cm 8Pin x1.

The item "9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951" is in sale since Tuesday, September 4, 2018. This item is in the category "Business & Industrial\Electrical Equipment & Supplies\Electronic Components & Semiconductors\LEDs, LCDs & Display Modules\LCD Display Modules". The seller is "lizvawy_tech" and is located in Shenzhen. This item can be shipped worldwide.


9.7inch E-Ink Display HAT for Raspberry Pi Zero/Zero WithZero WH/2B/3B/3B+ IT8951